Common Starting Issues in Trucking Applications---Part 2

Slow Cranking: For the starter to be cranking, the control circuit would have to be working. So, if battery and cable checks are within specification and the vehicle still cranks slowly, then it’s a slow cranking problem and it’s time to replace the starter.

Click No-Crank: Check the control circuit. If the starter does not contain an Integrated Magnetic Switch, or IMS, then a voltage drop test will need to be performed on the vehicle control circuit. If the starter does have an IMS switch function, then the technician will have to verify that the vehicle’s control circuit is providing voltage to the starter IMS.

No-Click No-Crank: When this occurs, power is not being sent to the solenoid, making it very unlikely that the issue is related to the starter motor. A diagnostic tool can help you diagnose the complete starting and charging system, including the alternator, batteries, starter motor and wiring. The diagnostic tool can perform a full system check in about 25 minutes, making it a great investment for your workshop. So in a poor starting environment, or when a starter motor has failed, what could be wrong?


Batteries – By now you should have tested your batteries and replaced any that were faulty. Don’t be tempted by the false-economy of leaving one poor quality battery in a bank of four. And you should look at your battery cabling, as this can often be less than optimum from new. In the diagram below, the top illustration shows the original battery cable layout, which results in the two inner batteries working hard and the outermost two never receiving optimum charge. In the diagram below (Pic 1) shows an easy solution to balance the workload of the battery banks.



Tips from:http://www.dieselnews.com.au